How to configure a Steren Com 818 wired repeater? –

How to configure a Steren Com 818 wired repeater?

Plug a network cable into the LAN port of the COM-818. Plug the other end into your computer’s ethernet port. Once you’ve connected your device (wired or wireless), open an internet browser. Enter the username and password shown below.

How to reset to factory state repeater com 818?

Connect the ADSL or cable modem to the COM-818 router at the LAN input and plug the router into the electrical outlet. To restart the router press RESET for 10 seconds.

How to install a Steren Com 8200 wifi signal repeater?

Turn on the COM-8200 and select repeater mode. Press the WPS button for seven seconds. Finally, press the WPS button on the router or modem that provides the internet service for seven seconds. Setup will take about 30 seconds.

How to restart my wifi repeater?

The way to reset the repeater is to press the WPS/RESET button 10 seconds to restore the factory settings. When the repeater display lights are off, and flash again, the reset is successful.

How to change the name of a TP Link extender?

Enter the web interface through the default IP 192.168.0.1 user and password admin.

1. – Select Network.
2. – In Host Name place name of our preference.
3. – Click Save.

How to change the name of my TP Link extender?

To change the name of the Wi-Fi network generated by the extender, select the Wireless Settings item from the left sidebar, type the name you want to assign to the network in the Range Extender WiFi Network Name (SSID) field and click the Save button to save the changes.

How to change TP Link network?

Select Network/Red> LAN located in the menu on the left side. Change the IP address to preference, then click Save. Note: After changing your IP address, you will need to type the new IP address of the router in the web browser to log in to the router.

How to change TP Link name and password?

Step 1 Open the web browser and enter the IP address of the router (default is 192.168.1.1) in the address bar and press Enter. Step 2 Enter the username and password in the login page, the default username and password is admin.

What is the username and password of TP Link?

In the case of the TP-LINK router, the username and password are «admin» in both cases. Now you have to enter the “Wireless Settings” section and configure the wireless settings.

How do I change the router name and password?

Normally you just have to go to the URL “192.168.1.1” and enter your current username and password. The password is usually 1234 or admin, but it depends on the model you have. Now, once inside, you must find the menu from which you can change the administrator password of the router.